Brave VH9934 Especificaciones descargar pdf (Pagina 22)

Operation

Do not attempt to operate the log splitter without fully understanding

all our instructions, safety precautions, and/or warnings. If any doubt

or question arises about the correct or safe method of performing any-

thing found in this or other Brave Products’ manuals, contact your

Brave Products’ dealer or call the Sales and Service representatives at our main

headquarters. Proper care is your responsibility.

When operating the log splitter make sure you

are standing in the safe operating zone as

shown in these pictures. You must stay in the

safe operating zone at all times when the

splitting wedge is in motion (whether extend-

ing or retracting). Never place any part of

your body into a position which would cause

an unsafe operating condition.

1. Set your log splitter on flat, dry ground.

Make sure you read all the recommenda-

tions from the “Safety” section before

using the log splitter.

2. Make sure both ends of the log you are

splitting are cut as square as possible.

This will prevent the log from sliding out of

position while under pressure. All logs

should be 24 inches long or shorter.

3. Start the engine using the instructions

from the engine manual. Warm up the

engine and hydraulic system by running

the engine at half throttle for 3 to 4 min-

utes, then advance the engine throttle con-

trol to maximum speed.

WARNING

Brave Products, Inc. 20 815-672-8861

c. Lock the rail assembly into a vertical

position with the rail latch.

d. Move the log under the splitting wedge

keeping your hands on the sides of the

log near the middle of the block. Cen-

ter the log making sure that the sawed

end is sitting on the large plate (base

plate).

Do not place your hands on top

of the log when loading the log

splitter. This is a very UNSAFE

method and could result in injury to your

hands.

CAUTION

815-672-8861 25 Brave Products, Inc.

1 2 ... 17 18 19 20 21 22 23 24

Comentarios a estos manuales

Sin comentarios

Brave VH9934 Especificaciones Pagina 22

Comentarios a estos manuales