Brave VH0622 Especificaciones descargar pdf (Pagina 13)

5. Lift the front leg and carefully roll the base

unit off the pallet.

6. Carefully stand the rail assembly in an

upright, vertical position.

Make sure the rail assembly is standing on

a flat, level area. If necessary, have a

helper steady the rail to prevent it from tip-

ping over. The rail assembly weighs

approximately 270 pounds and will cause

bodily injury if it falls on someone.

7. Carefully align the base assembly, using

the front leg, with the rail assembly.

Have someone hold the rail assem-

bly to prevent it from falling during

this part of the assembly.

8. Center the rail between the hinge plates

on the base assembly, as shown. Insert a

1/2-13 x 4-1/2 inch long hex head bolt

through rear top hole of the hinge plates

and rail. Install and tighten a 1/2-13 lock-

nut.

NOTE: To prevent the rail from binding, do

not overtighten the locknut. This connection

serves as the pivot point for the log splitter

from the vertical to horizontal position.

WARNING

800-350-8739

11

Brave Products, Inc.

Assembly Instructions

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 47 48

Comentarios a estos manuales

Sin comentarios